Dishwasher Repair Service Toronto & GTA

Buttons not working: Caused by panel wear, moisture damage, or control board failure. We test panel circuitry and replace damaged components.
Flashing lights or blinking display: Typically signals an internal fault or stuck cycle. We decode the brand-specific error and reset or repair as needed.
Won’t start, turn on, or latch: May involve the thermal fuse, door switch, or latch alignment. We test power flow and ensure the latch engages correctly.
Error codes on electronic panel: Each brand shows different codes. We use diagnostic tools to interpret and repair the specific failure shown.

Dishwasher door falls open: Broken door springs or faulty hinges are the common cause. We replace springs and adjust the door to close securely.
Latch not clicking closed: Often caused by wear or a misaligned door. We check for hardware wear or internal latch problems and repair accordingly.

Dishwasher won’t fill: Caused by a bad inlet valve, stuck float switch, or lack of water pressure. We inspect all fill components and test the valve.
Dispenser doesn’t release detergent: Commonly caused by a faulty solenoid or broken latch. We test the trigger and mechanism to restore detergent flow.
Dishwasher not getting water: May relate to a kinked water line, control issue, or valve malfunction. We trace the full water path to identify the issue.

Keeps running or won’t stop: Usually due to a timer fault or control board issue. We test electrical cycles and replace timers or boards when needed.
Starts then stops mid-cycle: Common with overheating, power supply dips, or loose door switches. We inspect for all possible cycle interruptions.
Runs too long: May be related to sensor failure, heating delay, or fill level problems. We diagnose cycle logic to reduce run time.
Dishwasher won’t dry dishes: Can stem from a failed heating element, high-limit thermostat, or rinse aid dispenser. We restore drying capability through full testing.

Smells like sewage or plastic: May involve food buildup, melted plastic, or burned wiring near heating elements. We inspect interior airflow and clean or replace parts.
Motor making noise or not spinning: Often a sign of worn bearings or an obstructed impeller. We disassemble the motor housing and replace worn parts.

Dishwasher not heating water: We test the element, thermostat, and relay for continuity and restore the heating function with OEM replacement parts if needed.

Has no power or won’t run at all: May be linked to a tripped breaker, blown fuse, or faulty wiring. We check all connections and restore safe operation.

Won’t start after power outage: Many units require a reset or experience control board faults after a surge. We reprogram or repair as needed.
How to clean dishwasher filters: We show you how to remove, rinse, and reinstall filters properly to maintain flow and prevent smells.
Still won’t start even with water: Can indicate control signal failures or a door sensor issue. We confirm all startup conditions are met.
How to replace a door seal: If your dishwasher leaks or smells, replacing the door gasket helps create a tight seal and prevents drips.
Not draining completely: Usually caused by partial clogs or backflow. We flush the system and check the pump thoroughly.
Won’t fill with water troubleshooting: Involves checking float switches, inlet valve voltage, and control system functionality.
Door won’t close properly: We realign racks, replace springs, or adjust hinges to restore a smooth, secure door seal.
Detergent not dispensing: We inspect for stuck dispenser latches, timer faults, or solenoid failures and replace if needed.

Dishwasher doesn’t clean dishes: Caused by weak water pressure, spray arm clogs, or failing circulation motors. We test the full wash system to restore performance.
Top rack not getting clean: Often due to a blocked upper spray arm or poor rack water access. We adjust or replace components to ensure top-to-bottom cleaning.
Dishwasher soap not dissolving: May be tied to low water temperature, a faulty dispenser, or spray coverage problems. We confirm the heating and release mechanisms are working properly.